Emerson Elevator Inverter EV3200-2S0002S | Potensi Elevator

Model NO.: EV3200-2S0002S

Quantity:

Product Description
Application Description

-Keywords-
Elevator Door Controller, Elevator Door Drive Supplier, EMERSON Elevator Door Inverter, EV3200 Door Controller, EV3200-2S002A, EV3200-2S004A, Lift Door Motor Controller

We are the wholesaler of the Kone Elevator Inverter EV3200-2S0002S, all of them are supplied directly by the factory. We sincerely looking for cooperation with elevator parts dealers or Maintenance companies from all over the world. Potensi is looking forward to working with you in the near future.

-Emerson elevator inverter EV3200-2S0002S Application-

Emerson elevator inverter Drive EV3200-2S0002S is the standard drive for the monospace system, The inverter is intended as a component for inverter system. If installed incorrectly, the inverter may present a safety hazard. The inverter uses high voltages and currents, carries a high level of quality, and it can be quickly and easily installed into your elevator system with an additional replacement kit.

-Product Description-

Brand: Emerson
Products： Emerson Elevator Inverter EV3200-2S0002S
OEM Parts: No
Model: EV3200-2S0002S

Items	Subitems	Specifications
Input	Voltage range	Single-phase AC power, 180V – 264V
Input	Frequency range	50Hz ± 5%, 60Hz ± 5%
Output	Voltage range	Three-phase: OV – input voltage
	Frequency range	0Hz – 128Hz
	Overload ability	150% rated current for 1 minute, 180% rated current for 10 seconds
Main control functions	Load motor type	Three-phase AC asynchronous motor, three-phase AC synchronous motor
	Modulation mode	Optimized space voltage vector PWM modulation
	Control algorithm	Sensorless vector control, vector control with speed sensor
	Operation mode	Two modes: 1. The inverter operates as an inverter specially used for controlling the elevator door (elevator door control mode), 2. The inverter operates as a general purpose inverter
	Frequency resolution	Digital setting: 0.01 Hz
	Door width auto learning	The inverter operates at the auto-learnt speed, and operates in the logic procedure of close door (CD) –open door (0D)—CD—stop. After the auto-learning operation, the door width information is saved and the auto learning process is over
	Auto tuning of motor’s parameters	Purpose of auto tuning function of inverter is to obtain the motor’s parameters automatically, and these parameters will be saved automatically after the tuning process is over
	Speed-adjusting range	Under rated load condition, 1:100 for vector control with speed sensor; 1:50 for sensorless vector control
Operation functions	OD, CDcontrol command input	Terminal control mode; keypad control mode; communication control mode (reserved)
	Frequency setting	Set the frequency via keypad; communication control mode (reserved)
	Multi-function terminal input signal	External reset signal, light curtain signal, safety edge signal, OD position limiting signal, CD position limiting signal, OD speed decrease signal, CD speed decrease signal, OD prohibition signal, torque maintaining signal, slow OD and CD signals, lock signal, emergency firemen service (EFS) signal, rush hour operation enable operation, operation enable signal, auto-learning command signal
	Output signal	3 relay-output: 250Vac/2A (cos0=1), 250Vac/1A (cos0=0.4), 30Vdc/1A
Display	4-digit LED display	Running frequency, reference frequency, output voltage, output current, output torque, DC bus voltage, status of input terminals, status of output terminals, door-operating position (pulse number)
Protection functions		Over current protection, over voltage protection, low voltage protection, over heat protection, overload protection, output phase failure protection, motor protection, motor tuning error alarm, parameter setting error alarm, door width auto-learning error alarm, OD/CD error alarm, pulse generator (PG) error alarm, current detection circuit fault alarm, EEPROM read/write error alarm, over-speed protection
Environment	Application environment	Inside, free from direct sunlight, dust, corrosive gas, combustible gas, oil mist, steam, water drop, and so on
	Altitude	Lower than 1000m. Max altitude: 3000m (deration curve should be observed at 1000m — 3000m: derated 10% for every rise of 100m)
	Working temperature	-10°C — + 40°C, temperature change less than 0.5°C /minute Must be derated above 40°C: The output current must be derated 2% for every rise of 1 °C. Max temperature: 50°C
	Humidity	Less than 95%RH, no condensation
	Vibration	3.5mm (2 — 9Hz), 10m/s2(9 — 200Hz), 15m/s2(200 — 500Hz)
	Storage temperature	-40°C — + 70°C
Structure	Protection	IP21
Structure	Cooling	Forced air cooling (EV3200-250004A and EV3200-2500045) Natural air cooling (EV3200-2S0002A and EV3200-250002S)

-Emerson Elevator Inverter EV3200-2S0002S Shipping Reference-

-Factory and Warehouse-

Click to Download Catalogue here

-Additional Info-

Packaging: Export Packing
Transportation: Fedex, UPS, DHL, TNT, EMS, Sea, Land and Air transportation, etc.
Place of Origin: CHINA
Certificate: EN115, CE, Gost-R, SASO, VOC, KTL, UL, CSA
Payment Type: T/T, Western union, Paypal, L/C, Credit Card and so on.
Incoterm: CFR, CIF, FOB, FCA, CPT
Delivery Time: About 7 working days against payment as generally

-Related Products-

Inverter model	Rated input current (A)	Rated capacity (kVA)	Rated output current (A)	Motor power(kW)
EV3200-2S0002A	2.65	0.5	1.3	0.2
EV3200-2S0002S
EV3200-2S0004A	5.3	1.0	2.5	0.4
EV3200-2S0004S

RFQ
——————
Q1. (Whole elevator) What information is absolutely needed before asking for the price?
A. Loading capacity or how many persons? ( eg. 6 persons for 450kg,8 persons for 630kg, 10 persons for 800kg, etc..)
B. How many floors/ stops/ doors?
C. What's the rated speed?
D. It will be with a machine room or without machine room?
E. What's the step width, lifting height, and angle degree if it's the escalator?
Q2. (Spare parts of Lift and Escalator) What information is needed before asking for the price?
(1) Pls tell us the elevator or escalator brand name.
(2) Pls, send us the picture of that spare part, and especially for the data plate with specifications.
(3) Pls, tell us the order quantity. ( how many pcs you needed?)
Q3. What about the packaging?
All elevator parts will be packed into standard exported Plywood boxes.

Related Tag
——————